wire
Showing all 6 results
-
Hot Rod Indicators, Relays & Flashers
C4 Relay Pack (WI-C4)
- 4 relays in a single compact unit
- Each 30 amp relay is double throw.
- Hot or ground trigger
- Relays can be linked for special functions
- No programing, just set a few onboard switches
- Instructions show several relay combo circuits
- Great for upgrading to new sleek switches
- ID your circuits right on the cover
SKU: WI-C4 -
Hot Rod Indicators, Relays & Flashers
Polarity Reversing Module (#L07W-25)
Power window motors, power trunk lifts, door locks, etc. need to reverse the direction of rotation of the motor in order to work. This is done by reversing the voltage polarity to the motor wire leads. This Reversing Module is needed when you want to use a switch that doesn’t automatically switch (reverse) both the positive and ground to the electric motor (such as a 3-wire switch or remote control).
Just 1/2″ square x 5/8″ wide – small but mighty!
SKU: L07W-25 -
Wire Routing for Hot Rods
Billet Wire Port (B16)
Here is a great way to dress up the area of the firewall where the wiring harness goes through. The Wire Port main body is 2″ dia. with a 1-1/2″ inside dia. and is secured to the firewall around the wire bundle hole with four (4) truss head screws. A 1″ x 13/16″ deep cut-out in the Wire Port body allows the wire bundle to exit close to the firewall (a rubber grommet is included for smaller wire bundles). The body is then capped off with an attractive machined cover which has three (3) ball-milled grooves. The design allows for the wire bundle to be installed before the final attachment of the Wire Port is done. Attractive, functional and at a very reasonable price.
SKU: B16 -
Wire Routing for Hot Rods
Billet Wire Pass-through (B21)
A really attractive way to dress up the area where the wires come through the firewall. Unit measures 1-1/2″ wide X 2″ tall X 1″ deep with a wire exit size of 1″ wide X 3/4″ deep. Blind fastens from behind for that smooth look. Hardware and template included.
SKU: B21 -
Wire Routing for Hot Rods
Billet ECU Wire Pass Through (WI-001)
An attractive cover with machined grooves to dress up where wire bundles pass through the firewall. This wire pass through was designed with large Fuel Injection harnesses in mind. The pass through comes with a fitted grommet with a 1″ precut split top hole for ease of installation and can be trimmed. The grommet can be opened up to a maximum of 1 5/8″ and has relief cuts to assist with trimming. The design of the pass through allows this piece to be added onto a completed vehicle with minimum effort.
Overall dimensions are 4 5/8″ tall x 2 1/4″ wide x 11/32″ deep on top and 2 1/8″ deep on bottom.
Inside dimensions are 3 3/4″ tall x 1 3/4″ wide x 5/8″ deep on top and 1 15/16″ deep on bottom.
SKU: WI-001
