1/4″ skinny lens is no longer available. Please see item #L58SMBT
Out of stock
1/4″ skinny lens is no longer available. Please see item #L58SMBT
$105.00
Out of stock
1/4″ skinny lens is no longer available. Please see item #L58SMBT
Weight | 0.00000000 lbs |
---|---|
Dimensions | 0.00000000 × 0.00000000 × 0.00000000 cm |
Metal Toggle Switch, 7/8” long for right or left turn indication, center off. Good looking switches control 40 amp brake light override circuitry to let you use a single brake/turn bulb (such as an 1157 bulb). Mount in the dash or console. Wire leads, instructions and schematic. (Uses a single two-prong flasher, not provided.) Now with our new compact Turn Signal Module – just 1-1/2″ square X 7/8″ high.
NEW AND IMPROVED! Our new 2mm version of damping material is 33% thicker than our original material.
Boom Mat is a high quality simple and effective solution in eliminating the low frequency noise problems found in structure-borne vibrations caused by typical automotive noise sources. Simply trim to desired size, peel backing and apply to a clean surface.
Boom Mat is constructed of a viscoelastic polymer layer protected by a durable aluminum wear surface and it’s strong adhesive backing is unaffected by extreme hot and cold temperatures and can be applied to horizontal, vertical and inverted areas on metal, plastic, fiberglass and most other automotive surfaces. Available in a variety of sizes for a cost effective installation.
Use as a first layer for areas with contours and bends for vibration damping needs
Applications
What’s in it for you…
|
Where to use:
|
When using LED’s for turn signals your regular flasher doesn’t work right anymore because the LED’s don’t pull enough amperage to trigger it. This “dummy load” resistor wires in parallel with the LED to add the necessary amperage draw. One dummy load per side is usually sufficient. (Sold only in Pairs)