hinges
Showing all 6 results
-
Specialty Flashers & Relays
Power Cowl Vent Kit (L34)
Give your cowl vent a lift with this powerful gear motor kit that comes complete with gear motor, brackets, hardware, interior switch, wire, connectors, and instructions. Steel bracket for cowl can be bolted or welded. Attractive 5″ aluminum rod arm gives a clean look. Motor with mounting bracket and lever arm measure 2-1/2″ wide, 4″ high and 3-1/4″ deep including motor, not including 5″ connecting arm. Also works for power glove box door.
The motor is not waterproof.
SKU: L34 -
Hood and Trunk Hinges
Steel Trunk Hinge Kit (CA-STHK)
From Carolina Custom – No visible welds when installed. Stainless steel attaching screws. Includes installation kit with 36″ bracket (part in photo is smaller for photographic purposes, bracket may be shortened to fit your specific application), pivot pins, and tabs for pivot pins Instructions.
SKU: CA-STHK -
Hood and Trunk Hinges
Power Trunk Lift Kit 100# Actuator (CA-PTL100)
Carolina Custom’s Power Trunk Lift Kits
Power Trunk Lift Kit 100# Actuator
Uses an industrial linear actuators for power – not just a window regulator. Works through a single pivot hole so there’s no ugly slot in your trunk upholstery. Only the billet arms and trunk bracket show when installed. Has all the hardware, brackets, arms and switch. The steel frame is designed to be able to install on either side of the trunk.
SKU: CA-PTL100 -
Hood and Trunk Hinges
Power Trunk Lift Kit 200# Actuator (CA-PTL200)
Carolina Custom’s Power Trunk Lift Kits
Power Trunk Lift Kit 200# Actuator
Uses an industrial linear actuators for power – not just a window regulator. Works through a single pivot hole so there’s no ugly slot in your trunk upholstery. Only the billet arms and trunk bracket show when installed. Has all the hardware, brackets, arms and switch. The steel frame is designed to be able to install on either side of the trunk.
SKU: CA-PTL200 -
Hood and Trunk Latches
Trunk/Hood Latch and Striker (D03)
This little beauty is called a Rotary Claw Latch. It’s spring loaded, “slams” shut just like a bear claw latch and can be used in a variety of applications like trunks and hoods. It is 1.8″ high from the mounting surface to the top, 1.25″ from the mounting surface to the striker center and the attachment holes are 3.25″ center-to-center. The finish is zinc yellow chromate. Latch has cable release mechanism below the mounting surface. Striker included.
SKU: D03
