Optional mounting clip package. If your rear window is slanted, curved or split glass you may want to order the optional mounting clip pack. It includes brackets and the necessary hardware to adjust the light to the perfect viewing angle.
Optional mounting clip package. If your rear window is slanted, curved or split glass you may want to order the optional mounting clip pack. It includes brackets and the necessary hardware to adjust the light to the perfect viewing angle.
$12.00
Optional mounting clip package. If your rear window is slanted, curved or split glass you may want to order the optional mounting clip pack. It includes brackets and the necessary hardware to adjust the light to the perfect viewing angle.
Weight | 0.00000000 lbs |
---|---|
Dimensions | 0.00000000 × 0.00000000 × 0.00000000 cm |
If you aren’t into flush mounting taillight or 3rd brake light lenses into the body, these stunning machined billet aluminum frames work with our L58 kits to allow you to surface mount the lens on the outside of the sheet metal while the LED’s and housing attach to the inside. The large L58 Frame is 16-3/4″ long X just under 1″ wide. It will protrude .400″ off the surface. They accept our lenses perfectly (as shown). All other parts (lens, LED’s, housing, etc) are in the flush mount kits, just add these frames for flat surface mount installation. 3rd Brake Light kits need one frame, Taillight Kits need two frames.
We’ve taken Pedestal 3rd Brake Lights to a new level! This gorgeous piece is 16-5/8″ wide, 3/4″ high (body), 1-1/8″ deep and only 2″ tall including the swivel base. 60 super bright red LED’s are split into 3 groups of 15-30-15 so that you have a 30 LED center 3rd brake light and (2)-15 LED turn signal/ brake lights. You could also add our LED Conversion Kits to get taillight and turn/brake or wire then all as one big and bright 3rd brake light.
Now you can feel safe knowing the cars behind you will see your brake lights. This slick little unit attaches to the inside of your rear window. For easy removal when you’re at a judged show attach the light with the included suction cups. For a more permanent installation double sided tape is also included. The light is divided into 3 sections, letting you use it for turn signals as well as brake lights. Works with either positive or negative ground vehicles. Instructions included. This light is 12 “ long , 5/8” tall & 7/8” deep.
Looking for more LIGHT in the rear of you 6V vehicle? We now have a Led 3rd brake light that will wire into you 6v system. The light meassures 12″ long, 5/8″ high and 7/8″ deep. Mount the light on to your back window using either the 2 way tape system or a temporary install with the suction cup system so you can take it down when you get to that classis car show. There are multiple wiring diagrams to follow depending on if you what your turn signals to be wiried into the light or not. This light comes with everything you need to complete the install fast and easy.
Note: If your rear window is at an angle and the light will point more up than back ask about the swivel mounting system!