Cable Installation Kit for Latch Releases (B20C)
For Two Doors:
Get all the pieces to help you connect your latch and latch release. 6+ feet of cable and sheathing (cut to length for 2-doors), 8 sets of plastic clips, screws and nuts. Compression sleeves (fixed end) and cable adjusters.
$20.00
For Two Doors:
Get all the pieces to help you connect your latch and latch release. 6+ feet of cable and sheathing (cut to length for 2-doors), 8 sets of plastic clips, screws and nuts. Compression sleeves (fixed end) and cable adjusters.
| Weight | 0.00000000 lbs |
|---|---|
| Dimensions | 0.00000000 × 0.00000000 × 0.00000000 cm |
Related products
-
Remotes & Keyless Entry Systems
Gear Motor Actuator (WI-29)
For Gator-Jaws and some original latches made after about 1960, these actuators will provide the power needed to trip the latch. This gear motor actuator has 12 pounds of both push and pulling power. With 7/8” of travel you can use it for door locks, trunk latches and more. These will also work for door locks when used with a polarity reversing module (such as our #L07-W). The actuator comes with the mounting and connecting hardware shown. (Actuator measures 5″ long x 2″ High x 1″ Deep) The unit works in both directions so these are great for power lock & unlock doors.
SKU: WI-29 -
Cables and Cable Releases
Emergency Door Release Kit (TP-BKD-1)
Even the very best electrical entry systems could go bad. This Emergency Door Release Kit gives you the mechanical back-up way to trip the driver door latch and get into your car. Kit contains 8+ feet of encased cable, stainless steel braided door wire loom with billet ends to run the cable through and into the door, billet pull knob with set screw, cable clips and mounting hardware. Easily run into the engine compartment or under a fender well. Why leave yourself unprotected? Made in America by Itsashoka Innovations.
SKU: TP-BKD-1
