Cable stop Only for 1/16″ cable.
“No-fray” end cable stop 1/16″ Cable (CC-STOP)
Cable stop Only for 1/16″ cable.
$7.50
Related products
-
Cables and Cable Releases
Emergency Door Release Kit (TP-BKD-1)
0 out of 5(0)Even the very best electrical entry systems could go bad. This Emergency Door Release Kit gives you the mechanical back-up way to trip the driver door latch and get into your car. Kit contains 8+ feet of encased cable, stainless steel braided door wire loom with billet ends to run the cable through and into the door, billet pull knob with set screw, cable clips and mounting hardware. Easily run into the engine compartment or under a fender well. Why leave yourself unprotected? Made in America by Itsashoka Innovations.
SKU: TP-BKD-1$49.00 -
Hot Rod Power Window Switches
4 Door Dimpled 3 Wire Switch Kit (L39B4DR)
0 out of 5(0)Beautiful billet 3 wire power window switches now in kits for 4-door cars. Comes with dimpled rockers. You get a 4 switch panel for the driver’s door and 3 single switch panels for each of the other doors.
Kit includes: switches with panels, polarity reversing modules, wiring connectors, and instructions.
Don’t know if you have Polarity reversing Motors? See the Product Instructions Tab to determine if your motors are Polarity reversing or Non-Polarity reversing.
SKU: L39B4DR$459.00 -
Wire Routing for Hot Rods
Billet ECU Wire Pass Through (WI-001)
0 out of 5(0)An attractive cover with machined grooves to dress up where wire bundles pass through the firewall. This wire pass through was designed with large Fuel Injection harnesses in mind. The pass through comes with a fitted grommet with a 1″ precut split top hole for ease of installation and can be trimmed. The grommet can be opened up to a maximum of 1 5/8″ and has relief cuts to assist with trimming. The design of the pass through allows this piece to be added onto a completed vehicle with minimum effort.
Overall dimensions are 4 5/8″ tall x 2 1/4″ wide x 11/32″ deep on top and 2 1/8″ deep on bottom.
Inside dimensions are 3 3/4″ tall x 1 3/4″ wide x 5/8″ deep on top and 1 15/16″ deep on bottom.
SKU: WI-001$119.00 – $124.00 -
Hot Rod Power Window Switches
4 Door 2 Over 2 3 Wire Switch Kit (L39B2/2-4D)
0 out of 5(0)Beautiful billet 3 wire power window switches now in kits for 4-door cars. Comes with dimpled rockers. You get a 2 over 2 switch panel for the driver’s door and 3 single switch panels for each of the other doors. The billet panels and rockers have a brushed aluminum finish.
Kit includes: switches with panels, polarity reversing modules, wiring connectors, and instructions.
Don’t know if you have Polarity reversing Motors? See the Product Instructions Tab to determine if your motors are Polarity reversing or Non-Polarity reversing.
SKU: L39B2/2-4D$569.00