1/4″ skinny lens is no longer available. Please see item #L58SMBT
Out of stock
1/4″ skinny lens is no longer available. Please see item #L58SMBT
$105.00
Out of stock
1/4″ skinny lens is no longer available. Please see item #L58SMBT
Weight | 0.00000000 lbs |
---|---|
Dimensions | 0.00000000 × 0.00000000 × 0.00000000 cm |
If you no longer have the original turn signal/4-way relay module or switch and still are using your original style taillights, this wiring will restore 4-way capability without the expense ($50 – $70!) of a new module and wiring. Also works with our Turn Signal Relay Pack if you are switching to non-separate turn signal/brake lights like 1157 bulb units. Use with your own On/Off switch or see our switch selection above. (switch not included)
Boom Mat Spray-On sound deadening is perfect for reducing unwanted road noise and deadening vibrations in those hard to reach places such as trunk interiors, fender wells, undercarriage, body panels, rear quarters and inside door panels to name a few. Boom Mat Spray-On also serves as a thermal barrier insulating against unwanted heat.
Whether you are looking for a quiet ride by eliminating squeaks, rattles, vibrations and unwanted engine and road noise, the benefits of Boom Mat Spray-On sound deadening can be used on any vehicle. Boom Mat Spray-On can be applied in multiple layers for even more sound deadening while handling temperatures up to 300 degrees F. Can be applied to non-coated surfaces and can be top coated with paint after only 6 hours of dry time. Boom Mat Spray-On is VOC (Volatile Organic Compounds) compliant in all 50 states.
Cool Tape is a flexible and super strong self-adhesive thermal insulating tape capable of protecting up to 2000°F of radiant heat. Made of one mil aluminized material bonded to a woven glass fiber heat resistant matting, Cool Tape is a ultra light weight heat reflective solution for wrapping wires, cables, hoses, fuel lines, covering seams and many other uses.  Comes as a 2″ x 30′ roll.
When using LED’s for turn signals your regular flasher doesn’t work right anymore because the LED’s don’t pull enough amperage to trigger it. This “dummy load” resistor  wires in parallel with the LED to add the necessary amperage draw. One dummy load per side is usually sufficient. (Sold only in Pairs)