Featured Products
C4 Relay Pack (WI-C4)
Gear Motor Actuator (WI-29)
Gear Motor Actuator (WI-29)
For Gator-Jaws and some original latches made after about 1960, these actuators will provide the power needed to trip the latch. This gear motor actuator has 12 pounds of both push and pulling power. With 7/8” of travel you can use it for door locks, trunk latches and more. These will also work for door locks when used with a polarity reversing module (such as our #L07-W). The actuator comes with the mounting and connecting hardware shown. (Actuator measures 5″ long x 2″ High x 1″ Deep) The unit works in both directions so these are great for power lock & unlock doors.
Toggle Battery Disconnect (L27TM)
A mini-momentary toggle switch controls this battery disconnect. It’s easy to install and easy to hide so it’s a perfect theft deterrent. Intended for “Dry” use only, install the toggle inside your ride. Push it once and the battery is connected, ready for use. Push it again and the battery feed is disconnected except for our auxiliary “hot” feed to the clock or computer or other items requiring power for memory. The solenoid is rated 110 amps continuous duty and 750 amps surge. Hardware, wire, connectors and detailed instructions included. There is NO electricity used when this unit is “on”, only when switching between on and off.
Swing Out Cup holder (#43053)
Add a useable hidden cupholder to your hot rod for those thirsty cruise days. The cupholder has the perfect size opening to harness the largest of quickie mart drinks yet still handles your typical water bottle just fine. This billet aluminum swing out design swivels under the dash or even your seat for that tidy hidden look. The cupholder has a moveable latching under support so it is very compact when put away. Stop limiting yourself on what you drink in your car because it doesn’t have a locking lid and add a cupholder today.
What's New
C4 Relay Pack (WI-C4)
Backup Monitor Console Camera – Through Hole Design (IT-MON-TH)
A Backup Screen for Your Console!
When we introduced our mirror /screen backup system it was a huge success but many folks need a unit for their center console. Well here it is. The large 5″ screen is mounted in a billet frame measuring 5-¼” wide by 4″ tall. You will need less than an inch of backspace. Sold with either a through hole or license plate mounted camera.
Backup Monitor Console Camera – License Plate Mounted Design (IT-MON-LP)
A Backup Screen for Your Console!
When we introduced our mirror /screen backup system it was a huge success but many folks need a unit for their center console. Well here it is. The large 5″ screen is mounted in a billet frame measuring 5-¼” wide by 4″ tall. You will need less than an inch of backspace. Sold with either a through hole or license plate mounted camera.
Clearance Items
Vertical Round LED Boot Indicator w/Boot, Ford AOD
Vertical Round LED Boot Indicator w/Boot, Ford AOD
Lokar’s Vertical Billet Aluminum LED Boot Indicator with Boot and a brushed aluminum finish. Sensor and remote kits required are sold separately.
Features:
