Shop
Showing 261–280 of 349 results
-
Hot Rod Wire Harness Kits and Parts
Rebel Wiring 21 Circuit Hot Rod Wiring Harness
This 21 Circuit takes the Basic Muscle Car Harness then we added Power Doors, Power Windows, Power Seats, Cruise and Electric Fan Relay Control wire. Assembled with heavy duty SXL wire labeled every 6″ and bundled for easy installation. Comes with Fusible link, 1 1/4 Rubber grommet for firewall. Instructions and Fuse Label.
KIT INCLUDES BASIC AUTO ELECTRICITY BOOK
SKU: WI-F21 -
Hot Rod Wire Harness Kits and Parts
VW Beetle Bug Deluxe Wiring Harness
16 Circuit universal harness, Horn Relay, Lights, cell phone charger, Hazard, Gauge Power, Wiper, Brake Lights, AC-Heat, Back-up,Radio Constant, Turn signal, Dome light, Trunk Light and 2 Accessory Circuits both Keyed.
12 Fuse panel with 3 prong flasher and Horn Relay.
Assembled with heavy duty SXL wire, labeled every 6″ and bundled for easy installation.Glass body buggys should use this BUG HARNESS
KIT INCLUDES BASIC AUTO ELECTRICITY BOOK
SKU: WI-VW -
Hot Rod Wire Harness Kits and Parts
VW Complete Bus Deluxe Wiring Harness
V.W.Bus Plus Universal Harness 12 volt
Our Bus Harness takes our standard Universal Bus Harness to the next level. This harness includes everything in the Universal Bus Harness and adds two (2) interior lights and two (2) accessory circuits. Perfect for the Custom Bus with a few extras. Also works well with single and double cabs.KIT INCLUDES BASIC AUTO ELECTRICITY BOOK
SKU: WI-BUS -
Hot Rod Wire Harness Kits and Parts
16 Circuit Rebel Diesel Full Wiring Harness
Rebel Wire 16 Circuit Diesel Wiring Harness
This Rebel Wire 12 fuse/16 Circuit universal diesel harness is perfect for your custom build using an older diesel engine. This kit includes circuits for Lights, signals, horn, 4 way hazards, gauges, wiper, radio and radio constant, trunk and dome lights, AC/Heat power, back-up lights, Glow plug volt sense input, ignition switch fuel solenoid, starter fuel solenoid, and engine cranking sense input.SKU: RW-DSL -
Hot Rod Wire Harness Kits and Parts
6-Volt Hot Rod Wiring Harness Kit
8 Circuit, Includes: horn, headlights, stop light, heater, radio, gauge power, turn signal and wipers. Wire is SXL, all sized for 6 Volts, labeled every 6″ as found in all REBEL WIRE kits. Turn signal flasher in fuse panel. Horn relay separate. Wires car or truck from front to rear.
SKU: RW-6V -
Specialty Flashers & Relays
Reminder Buzzer (32032)
A good Reminder buzzer should do it’s job but not be too irritating. This new unit is just right and looks good enough to mount on your dash (matches L75 Series switches) or you van hide it underneath. The ring and the salt shaker center light with a red LED when buzzer sounds. mounts in a 3/4″ hole, chome bezel is 7/8″
SKU: 32032 -
Hot Rod Power Window Switches
Light Clip for L39B Switches (L39B-Clip)
Now you can add illumination to any of our family of L39B Power Window and specialty switches. This Clip secures to the switch frame mounting screws and holds your choice of 5/32″ size LED (also sold separately). The LED shines between the billet rocker and face plate of the switch. We recommend using one clips on each side of the switch, for example for a L39BOD switch panel witch is a 2 switch panel using 3 clips would project an equal amount of light across the panel.
SKU: L39B-Clip -
Hot Rod Power Window Switches
Express Power Window Module (PW-EXP)
Now you can enjoy the convenience of “one touch” windows on your vehicle. This compact unit mounts inside your door and works with all polarity reversing motors. Simply tap your switch once and the window travels all the way up or down. While in motion just give the switch another tap to stop mid-way. This works with your remote too! Each express module comes with connectors, heavy duty mounting tape and instructions. Each 3″ by 2″ by 1″ module operates one window.
SKU: PW-EXP -
Custom Automotive Interior Trim Accessories
Round Brake & Clutch Trim (B01)
Small, round hole trim allows you to finish the brake and clutch pedal shafts and around the dimmer switch. Also great for around wires, hoses, harnesses or anything you want to trim. Choose from a solid machined part or our Split ‘n’ Pinned trim. Both are 2-1/4″ diameter with a 15/16″ diameter hole and stainless steel screws and rubber gasket (not in photo).
SKU: B01 -
-
Automotive Switches and Buttons
Mini-Rocker Switch (L55)
A sweet little jet black rocker switch with different versions to give you lots of options. The switch measures just 19/32″ x 13/16″ and is rated 5 amps max. except as noted.
Space doesn’t allow us to list all the possible things that we can do with these switches but if you can think it, we can probably do it, including … power window switch, power door locks, power trunk lift, turn signals, self-canceling turn signals, headlight – park lights, etc. Or just add one of our 40 amp relays to increase the circuit switching amperage.
SKU: L55 -
Discount Hot Rod Parts
2″ Auxiliary Small LED Rectangular Tail Lights & Turn Signal Lights
Your choice of Red LED’s.
These sealed units have 4 LEDs in a 2″ by 5/8″ lens. Available in red. They are single intensity. Add our dual intensity conversion kit to get a dimmer running light and a brighter turn signal.
SKU: L63-LED -
Custom Marker Lights, Hot Rod Exterior Lighting
4-1/4″ Flush Mount Amber Front Lights or Red Marker Lights L89
Custom Marker Lights, Hot Rod Exterior Lighting4-1/4″ Flush Mount Amber Front Lights or Red Marker Lights L89
The amber light has 12 super bright amber LED’s. The red light has 15 super bright red LED’s Both lights have clear lenses (4-1/4” long, 1/2” wide, 1/4” deep for sanding) with diffuser, dual intensity convertor, installation hardware and instructions.
SKU: L89 -
Hot Rod Exterior Lighting
4-1/4″ White Running Light with Amber Turn Signal (Pairs) L89WA
Each light contains (2) clusters of Bright White LED’s – 3 LED’s each – for running lights AND (8) Super Bright Amber LED’s for Turn Signals. Flush Mount Clear Lenses are 1/2″ wide x 4-1/4″ long x 1/4″ thick with diffuser. Mounting hardware included.
SKU: L89WA -
Custom Marker Lights, Hot Rod Exterior Lighting
Side Marker Flush Mount Kit (EL-SMK)
This is a complete sidemarker kit that includes a pair of amber and a pair of red flush mount marker lights. These lights use our new “skinny” flush mount lens that measures only 1/4″ X 1 3/4″.
Kit Includes:
- 2 – Red Waterproof 3 LED Buckets
- 2 – Amber Waterproof 3 LED Buckets
- EL-SMK: 4 – 3/8” Thick clear acrylic lenses for build-in flush installation with a small ¼” X 1 ¾” size
- EL-SMK5: 4 – 3/8″ Thick clear acrylic lenses for build-in flush installation with a medium 1/2″ X 1 3/4″ size.
- Hardware Pack
NOTE: This is a build-in kit requiring body working skills and is intended for vehicles that are under construction or modification.
SKU: EL-SMK -
Hot Rod Exterior Lighting
Bullet Beehive LED Taillights w/ Billet Base (L84)
Beehive lights are now available in large and small sizes
’50’s styling with 21st century technology. Each light has Super Bright Red & Orange LED’s in a Beehive light that has a neat star pattern. Machined Billet Base provides a high-tech finishing touch. Easily mounted to a flat surface using the hardware provided – only three holes needed to install. Dual intensity converter included. Use as a pair or in groups of four or six for that classic taillight look. These lights meet DOT/SAE requirement J592e and are so marked. Sold in pairs.
Overall dimensions for the original large beehives are 2-3/4″ dia. at the base x 2-7/8″ tall. The new small units are 2-1/4″ dia. at the base x 2-1/8″ tall
SKU: L84 -
Custom Switches for Hot Rods
Classic Button Style Brake Switch (33021)
We’re famous for our simple adjustable lever brake switch but they won’t work on every car so we now offer this simple button style switch. You set this up so that the pedal arm pushes on the button when the pedal is at rest. As the pedal moves the button releases completing your brake light circuit. This plastic switch has 1” of adjustment and is 3” inches long by ¾” in diam. Mounts in a ½” hole on your bracket.
SKU: 33021 -
Hot Rod Exterior Lighting, Hot Rod LED Brake Lights
Beehive LED Lights with Recessed Lighting Bezels in Amber or Red
Hot Rod Exterior Lighting, Hot Rod LED Brake LightsBeehive LED Lights with Recessed Lighting Bezels in Amber or Red
These are our Beehive lights mounted in a recessed stainless steel bezel that mount in a 2.75″ hole. They come in either Amber or Red and come with our LED conversion modules. These lights work as park lights and turn signals or brake as well with the reds. These lights are designed to be the simplest mounting lights on the market even from a blank slate. Sold in pairs.
SKU: EL-10# -
Hot Rod Exterior Lighting
Flush Mount Third Brake Light with Red Turn Signals (L58BT)
3rd Brake Light with Turn Signals This sweet light is split into 3 groups of 15-30-15 providing a 30 LED center 3rd brake light and (2)-15 LED turn signal/brake lights. You can also add our LED Conversion Kits to get taillight and turn/brake or wire them all as one big and bright 3rd brake light.
SKU: L58BT
