C4 Relay Pack (WI-C4)
Gear Motor Actuator (WI-29)
For Gator-Jaws and some original latches made after about 1960, these actuators will provide the power needed to trip the latch. This gear motor actuator has 12 pounds of both push and pulling power. With 7/8” of travel you can use it for door locks, trunk latches and more. These will also work for door locks when used with a polarity reversing module (such as our #L07-W). The actuator comes with the mounting and connecting hardware shown. (Actuator measures 5″ long x 2″ High x 1″ Deep) The unit works in both directions so these are great for power lock & unlock doors.
Toggle Battery Disconnect (L27TM)
A mini-momentary toggle switch controls this battery disconnect. It’s easy to install and easy to hide so it’s a perfect theft deterrent. Intended for “Dry” use only, install the toggle inside your ride. Push it once and the battery is connected, ready for use. Push it again and the battery feed is disconnected except for our auxiliary “hot” feed to the clock or computer or other items requiring power for memory. The solenoid is rated 110 amps continuous duty and 750 amps surge. Hardware, wire, connectors and detailed instructions included. There is NO electricity used when this unit is “on”, only when switching between on and off.
Swing Out Cup holder (#43053)
Add a useable hidden cupholder to your hot rod for those thirsty cruise days. The cupholder has the perfect size opening to harness the largest of quickie mart drinks yet still handles your typical water bottle just fine. This billet aluminum swing out design swivels under the dash or even your seat for that tidy hidden look. The cupholder has a moveable latching under support so it is very compact when put away. Stop limiting yourself on what you drink in your car because it doesn’t have a locking lid and add a cupholder today.
Steering Column Trim / Lightning Roll Cage Pass Through (B03N)
Give your steering column the finished look with our machined aluminum trim with heavy duty rubber seal. Made with StreetWorks unique Split ‘n’ Pinned design for easy installation – no column removal required. The ring measures 3.420″ I.D. and 4.800″ O.D. and includes stainless steel mounting screws. The rubber seal has an opening to fit GM and other columns measuring 1-3/4″ to approximately 2-1/8″ diameter. Some trimming may be required for larger diameters. Now with an additional grommet to fit 1-1/2″ diameter columns.
These trim rings also double as a pretty sweet finishing piece for your Ford Lightning roll cage pass through. Of course these will work for virtually any other roll cage pass through you can think of but they are commonly used in the Lightning application.
Power Cowl Vent Kit (L34)
Give your cowl vent a lift with this powerful gear motor kit that comes complete with gear motor, brackets, hardware, interior switch, wire, connectors, and instructions. Steel bracket for cowl can be bolted or welded. Attractive 5″ aluminum rod arm gives a clean look. Motor with mounting bracket and lever arm measure 2-1/2″ wide, 4″ high and 3-1/4″ deep including motor, not including 5″ connecting arm. Also works for power glove box door.
The motor is not waterproof.